95 accord (f22b2) head removal HELP!!!
#1
95 accord (f22b2) head removal HELP!!!
I have valve seals leaking and I suspect I have a bent/burnt valve I'm going to just replace head with a reman. My main concern is the lower intake manifold nuts I hear there a pain to get to .. Can I just pull the head and intake out together???
#2
Honda-Tech Member
Re: 95 accord (f22b2) head removal HELP!!!
You would be better off just pulling the manifold first. There is a coolant pipe that runs alongside the back of the block that is attached to the thermostat housing at the left side of the manifold. I was able to remove mine by using a 1/4" drive ratchet and various extenders.
#3
Re: 95 accord (f22b2) head removal HELP!!!
if you have the patience pulling it off first is fine, but really unbolt the thermostat, the coolant should already be drained, and you can just pull the intake manifold after it is off.
#5
Re: 95 accord (f22b2) head removal HELP!!!
You can get to a few of the bottom ones from the sides (left and right, see which ones), but the others you should approach from underneath with the car on jack stands. I found easiest to use a 1/8 inch socket wrench with an extension. Its much easier with the small ratchet, I suggest you get one for this job. You need a 12 mm socket.
Thread
Thread Starter
Forum
Replies
Last Post
yohimbine
Honda Civic / Del Sol (1992 - 2000)
6
07-31-2013 04:45 PM
THEUSED
Honda CRX / EF Civic (1988 - 1991)
5
01-28-2007 09:04 PM