Slipjack

I just bought a '93 Civic HB and when I bought it home to give it an oil change I found that the oil plug is stripped out. I might be able to unscrew it if I try hard enough, I just wanted to know if anybody knew any tricks that I don't know about to get it off.

Lmgrcivic

weld something to it and unscrew it and get a new one

Slipjack

Not bad, will need to drive it to my Dad's for a welder. Any other ideas before I go do that instead?

Deemeetree

Get a grinder, knotch a groove in the center, get your biggest/heaviest flathead, try from there. You can try Vise-Grips.

Slipjack

That'll work. Thanks. Tried the vicegrips. They just slipped around on the plug like the wrench did. Someone did a real number on it, multiple times.

If whoever did this was stupid enough to not only strip the oil drain plug, but to keep using it and stripping it more and more each time -- now I have to look at every single facet of this car to see what other stupid crap might have been done to it.

Hurricane

Worst case senario, you have to pull the oil pan while its full ($#@%$#@mess) and replace it with one that has a good plug.

extra cam needed

Use a plumber's pipe wrench

TurboTagTeam

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by Dimitri_EG8 &raquo;</TD></TR><TR><TD CLASS="quote">Get a grinder, knotch a groove in the center, get your biggest/heaviest flathead, try from there. You can try Vise-Grips. </TD></TR></TABLE>
Or use a dremal or something

SOHC4life 96

You could get a socket that is smaller than the plug bolt right now and hammer it on there and then see if that works. The socket should be expendable though.

Frozen E

Pick one up at your local hardware store. $4-10 TOPS.

tuphatt

get a strip bolt remover from Sears. It is like $20. Make sure you buy the metric version.

worked for my stripped bolted on the CAT.

Good Luck

00supercivic

yeah i would try the pipe wrench casue i had the same problem, and it came of in the first try. or if you have to you might have to get a bolt extractor form auto zone. and as far as gettin a new one you can get it from honda with a new crush washer for like 4 bucks, thats what i did. good luck

peiku

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by tuphatt &raquo;</TD></TR><TR><TD CLASS="quote">get a strip bolt remover from Sears. It is like $20. Make sure you buy the metric version.

worked for my stripped bolted on the CAT.

Good Luck</TD></TR></TABLE>

i would suggest this too. i bought a set and have never regretted it. i have taken out many stripped bolts.

nocturnaldragon

Those things are pure <U>****</U>. Get a pipe wrench.

T4eg

I just ran into the same problem. I took the pan off and drilled out the hole and welded a 3/8" pipe fititng in. (flush with inside pan) then using a 3/8 pipe plug as a drain plug

kkim

pipe wrench should work. just be sure to have a replacement plug on hand when you finally get the stripped one ut.